Our Kick Plates are covered with Polycarbinate laminate (also used for bullet proof glass!) which offers a very tough, scratch resistant and textured surfaces. This will last a long time and take a lot of abuse. Do not settle for vinyl laminate!
You can also chose to have your KP printed on heavy photo paper if you plan on putting Plexiglas over top of the KP and don't need adhesive or the tough Polycarbonate Laminate
Please use the options pull down menu if your Kick panel will be larger than 10" x 23" to add the appropriate additional cost.
You can create your own marquee or side art using one of the samples at arcade art library or your own design. Artwork you create must be the correct size and it should be at least 200dpi, but 266-300dpi is preferred. Leave the document in RGB mode which has a broader color range. Do not create a file in a lower dpi and then convert it to 300dpi, this only makes the file bigger and does not enhance the resolution. It will still come out blocky and actually worse then if you left it at a lower dpi. Start creating at 200 or 300 dpi at full size, in other words, if you are creating a 300dpi marquee that will print at 26x8” create it at that size. We will print it the size you send it. Design your artwork with the Marquee retainer in mind and leave a 1/2”-3/4” on the top and bottom empty.The file should be a .psd photoshop or .ai adobe illustrator file, or a .tif if using another program such as paintshop pro or Coreldraw.
Please use our convenient upload site after ordering to upload your file located